LockheedMartin/Onsite/EMAS

LMCO EMAS Final Setup Procedure

Laptop Network Requirements

• IP Address:

137.32.144.2

• Subnet Mask:

255.255.252.0

• Default Gateway: Blank

Connect to Reader

• Plug in USB Key

• Plug in Reader to POE (to local Laptop)

• Wait for Bootup

• Run Final Test Utility Application

• Scan Reader's VRSN (IP Address is automatically entered from IP Listing)

• Click Connect

a. If connection fails, Putty into unit and confirm IP Settings:

• See if an IP Address is listed:

ifconfig eth0

• If not, check if the Ethernet file is correct:

nano /etc/NetworkManager/system-connections/Ethernet

• It should contain the following (with the Reader's Static IP Address entered at STATIC.IP.ADDRESS.HERE):

[802-3-ethernet]
duplex=full

[connection]
id=Ethernet
uuid=78ecb3fd-e330-468b-b76b-92c1b22f7767
type=802-3-ethernet

[ipv6]
method=auto

[ipv4]
method=manual
address1=STATIC.IP.ADDRESS.HERE/22,137.42.144.1

• Set the correct permisisons for the file:

chmod 600 /etc/NetworkManager/system-connections/Ethernet

• Restart NetworkManager:

systemctl restart NetworkManager

• Retry Step 6

• Wait for Green Indication

Setup MUX

• Ensure MUX Settings is the current Tab

• Click Get MUX from Reader

• Verify Reader MUX Settings are correct by comparing:

MUX Map Settings
MUX Settings from Reader
Antenna Panel Diagram
Antenna Panel on Reader 

(If MUX Map and Reader MUX Settings Match, Get MUX from Reader is Green)

• Once correct settings are displayed, Click Send to Reader

• Click Commit

Verify Settings

1. While still on the MUX Settings Tab, Click Check Settings
2. Follow onscreen prompts
3. If Check Settings is Yellow, Repeat above "Verify Settings" Step 1.
4. If Check Settings is Green, Continue to next section

Update Reader and Configure / Collect Reader Data

1. Switch to Reader Configuration Tab
2. Click Connect to disconnect from Reader and again to re-establish connection
3. Click Run Configuration Script
4. Wait for Script to Run (May take a few minutes)
5. Watch for Completed Message
6. Verify Output Dialog Box

• Copy of Output files placed at: /Logs inside the program directory

Connect to Reader on TLS

• PuTTY into Reader and at root@hostname:~# console prompt enter:

openssl s_client -connect localhost:2020

• (Prints out OpenSSL Certification Information, then shows > RFID prompt)

• Disable TLS:

SET TLSSECURE DISABLED
COMMIT
EXIT

• Restart RFID Service:

systemctl restart rfid

• Connect to Reader normally:

nc localhost 2020

Test Hardware

1. Antennas and Inputs with Test Tag